Want a regional phone & address? Pick your area.
The Wash Light is on or flashing when the water level has not changed for a while, OR water is present, but the control does not detect the water level changing.
Verify that both the hot and cold water faucets are both completely open.
Turn off the water and remove the inlet hoses from the washer.
Remove any accumulated film or particles from the water inlet valve screens.
Turn on the water.
Check the household faucets to see if the hot and cold water faucets are turned on.
Make sure to open both faucets completely for proper fill.
Parts That May Need Replacement
Bearing puller set ($120), drum spider wrench ($85), multimeter ($85), and diagnostic software. Our technician arrives with $3,000+ in professional tools — your diagnostic is free.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Here's what a professional technician does to resolve this issue:
Verify that both the hot and cold water faucets are both completely open.
This repair requires bearing pullers, drum spider wrenches, and diagnostic software for control board calibration. Most homeowners find it safer and more cost-effective to have a licensed technician handle it.
High-voltage components and pressurized water lines create flood and shock risk. A single loose fitting can cause thousands in water damage. Our techs are licensed and insured — let them handle the risk.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Don't let error code Wash Light On or Flashing disrupt your day. A professional diagnosis takes about 30 minutes — and it's free when you proceed with the repair.
Licensed & Insured · 90-Day Warranty · Same-Day Appointments Available
Fixed or It's Free
Free Service Call & Diagnosis — no hidden fees, offer ends Sep 15
Kenmore error code Wash Light On or Flashing indicates: The Wash Light is on or flashing when the water level has not changed for a while, OR water is present, but the control does not detect the water level changing.. This is a medium-severity issue affecting your washer.
Verify that both the hot and cold water faucets are both completely open. Then, Turn off the water and remove the inlet hoses from the washer. Then, Remove any accumulated film or particles from the water inlet valve screens. There are 3 more steps — see the full troubleshooting guide above. If these steps don't resolve the error, contact a professional.
Repair costs for Kenmore Wash Light On or Flashing typically range from $100 to $500 depending on the specific cause. EasyBear offers free diagnosis when you proceed with the repair. Call (415) 795-7300 for a same-day appointment.