Washer Dryer Combo Control Board Replacement Cost

How much does a washer dryer combo control board replacement cost?#

A control board replacement on a washer dryer combo usually costs $240 to $610, with the everyday bill close to $425. Whether the shop fits a factory part or an aftermarket one, and how much bench time it takes to reach the board, decide if you pay nearer $240 or $610. Labor weighs as heavily as the part itself: a layout that lets a tech get at the control board quickly bills less time than one that forces a full strip-down of the machine. The work is routine for a pro: isolate the fault, fit the main board, and confirm the machine runs clean before packing up, which is why a firm quote is easy to give up front. The table under this answer lays out the part-plus-labor math behind that figure. Compared with the $1,000 to $2,500 for a replacement, spending on the main board pays off on all but the most tired units.

Washer Dryer Combo control board replacement cost

• What it does: the control board runs the electronics and cycle logic.
• Signs it is failing: a dead panel, unresponsive buttons, or cycles that quit partway.
• The repair job: diagnosing the board, fitting an OEM replacement, and confirming every cycle.
• DIY or pro: usually a technician job — a wrong board or a missed reprogram wastes the part.

Against a new washer dryer combo at $1,000–$2,500 installed, a control board repair at $240–$610 is usually the cheaper fix — unless the washer dryer combo is already old or has other faults.

Pro note: a technician rules out a failed door switch or a loose harness before condemning the board, since those mimic a dead board for far less money.

Is replacing the control board on a washer dryer combo worth it?#

For a washer dryer combo under roughly 8 years old, putting $240 to $610 into the board is money well spent — it recovers a working machine for a sliver of the $1,000 to $2,500 a replacement runs, and nothing else on the machine is near the end of its life. The judgment call is an aging machine with other symptoms brewing; there, a near-$610 repair on the control board is money many owners would rather redirect to a new one. A useful test: if the main board is the only fault on an otherwise solid unit, fix it; if the machine is old and the repairs are piling up, price out a replacement first. Either way, a licensed EasyBear pro pins the fault and quotes the main board before any part is ordered, so you never pay to guess.

Washer Dryer Combo Control board replacement cost: FAQ#

How much does a washer dryer combo control board replacement cost?#

A washer dryer combo main board replacement generally runs $240–$610, and about $425 on a routine job. Part grade, brand, and how hard the board is to reach are what set where you land.

Is replacing the main board worth it, or should I just buy new?#

Usually worth it on a machine that is not too old — $240 to $610 is minor next to the $1,000 to $2,500 of buying new. Replacement only wins once the machine is aging and other repairs are stacking up behind this one.

What makes the control board fail?#

Common causes are power surges, moisture reaching the electronics, and simple age-related component failure. The warning signs to watch for are a dead panel, unresponsive buttons, or cycles that quit partway.

Can I replace the main board myself?#

Most owners leave this one to a pro: reaching the main board and confirming the diagnosis takes the right tools, and a wrong part is money down the drain. A technician also carries the exact component and stands behind the work.

How long does the job take?#

Plan on about an hour for the swap itself, plus a test cycle afterward to confirm the fault is cleared. A tech who has done it before tends to work at the fast end of that estimate.