How much does a dryer cycling thermostat replacement cost?#
A cycling thermostat replacement on a dryer usually costs $90 to $180, with the everyday bill close to $135. The spread reflects the grade of part you pick and how buried the cycling thermostat sits — a Speed Queen or Speed Queen commands more for the same component than a builder-grade model. Two machines with the same fault can quote differently once you factor in how long it takes to expose the temperature control on the machine. Expect the technician to verify the symptom, rule out the cheaper look-alike faults, and only then replace the temperature control — that discipline is what stops you paying for the wrong part. Below, the cost breakdown shows what the component and the bench time each contribute to the total. Set against the $450 to $1,300 a new dryer costs to buy and install, restoring the thermostat is the economical move on any machine with good years left in it.
Dryer cycling thermostat replacement cost
- What it does: the cycling thermostat switches the heat on and off to hold the drying temperature.
- Signs it is failing: a unit that runs cold, overheats, or never reaches temperature.
- The repair job: testing the thermostat and fitting a replacement on the blower housing.
- DIY or pro: a moderate DIY job once the back panel is off.
| What you pay for | Typical cost |
|---|---|
| Part plus basic labor | $90 |
| Typical repair | $135 |
| Premium part or hard access | $180 |
| A new dryer, installed | $450–$1,300 |
Against a new dryer at $450–$1,300 installed, a cycling thermostat repair at $90–$180 is usually the cheaper fix — unless the dryer is already old or has other faults.
Pro note: a tech checks the vent for a blockage too, because restricted airflow trips the thermostat and fakes a failed part.
Is replacing the cycling thermostat on a dryer worth it?#
If the dryer is newer, the answer is an easy yes: the $90 to $180 outlay is far below the $450 to $1,300 a fresh dryer would cost, and the repair leaves the rest of the machine untouched. The decision tightens on an older unit. Once the unit carries other tired parts and this job climbs toward $180, you are pouring real money into a machine that may need more soon — and a new dryer starts to make sense. A useful test: if the thermostat is the only fault on an otherwise solid unit, fix it; if the machine is old and the repairs are piling up, price out a replacement first. When you are ready, an EasyBear technician can confirm the diagnosis on the first visit and give a firm price on the thermostat, diagnostic included.
Do You Have the Right Tools?
Gas leak detector ($130), thermal fuse tester ($95), belt tension gauge, and vent inspection camera ($180). Our technician arrives with $3,000+ in professional tools — your diagnostic is free.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Dryer Cycling thermostat replacement cost: FAQ#
How much does a dryer cycling thermostat replacement cost?#
A dryer thermostat replacement generally runs $90–$180, and about $135 on a routine job. Part grade, brand, and how hard the cycling thermostat is to reach are what set where you land.
Is replacing the thermostat worth it, or should I just buy new?#
Usually worth it on a machine that is not too old — $90 to $180 is minor next to the $450 to $1,300 of buying new. Replacement only wins once the machine is aging and other repairs are stacking up behind this one.
What makes the temperature control fail?#
Common causes are heat, vibration, and contact wear that eventually opens the circuit. The warning signs to watch for are a unit that runs cold, overheats, or never reaches temperature.
Can I replace the thermostat myself?#
A confident DIYer can often manage it when the thermostat is easy to reach and the diagnosis is solid. If any of that is in doubt, a pro removes the guesswork and warranties the repair.
How long does the job take?#
Plan on under an hour for the swap itself, plus a test cycle afterward to confirm the fault is cleared. A tech who has done it before tends to work at the fast end of that estimate.
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.


