The short answer on F1E1
F1E1 means the manufacturer's documentation points to a problem with the oven control or its associated wiring. In practice the oven may not carry out the function you select, or may refuse it outright; reset it once, and have the control and its wiring tested if F1E1 returns.
Error codes
Reference| Code | Meaning |
|---|---|
| F1E1 | There may be a problem with the Oven Control, or the associated wiring. |
Behaviour that comes with F1E1
- A function that starts and stops at once — The control did not carry the function through.
- F1E1 straight after selecting a function — The board reported the failure as soon as it was asked.
Why F1E1 appears, in likelihood order
- The oven control — First, as the documentation names it: the control board itself has failed.
- The wiring connected to the oven control — Second, as the documentation names it: a loose, damaged or burnt connection in the control's wiring.
Diagnosing F1E1: the order that saves time
- Note which function failed — Bake, broil, convection or clean; it helps the technician narrow the fault.
- Reset at the breaker — Clears a one-off fault.
- Try the other functions — If only one fails, note it: it narrows the check the technician makes on the control and its wiring.
- Have the oven control and its wiring tested — Done under power by a technician.
Clearing F1E1 and checking it safely
- Reset the oven — Breaker off for a minute, then on.
Tools: breaker panel accessAbout 3 min
- Test each function briefly — Try bake, then broil, then any other mode, and note which ones fail.
About 10 min
- Listen for clicks — A click without heat and silence without heat point to different faults; note which you hear.
About 2 min
- Leave the control to a technician — The oven control carries line voltage on its terminals.
Safety on this appliance
Unplug the range or switch off its breaker before removing any panel; a capacitor can hold a charge after the power is off. Relay boards carry heater current, and a burnt terminal can arc, so switch off the breaker if you smell burning. On a gas range, if you smell gas, do not switch anything on or off, leave the building, and call the gas utility or emergency services from outside.
Reset or repair: where the line is
Call if F1E1 returns after a reset, especially if it affects one function every time, or if you smell burning when the oven runs. The technician tests the oven control and its wiring connections before replacing the control, and a note of which function failed shortens that work.
Model coverage and limits
This reading of F1E1 applies to Amana ovens whose control reports a problem with the oven control or its wiring with this code, as the table states. Other controls report faults in other formats; a model-specific page, where one exists, is the better guide. None is listed for F1E1 yet; begin at the Amana oven code index below.

