F4 in brief
For F4, the brand’s guidance is to make sure the pot or pan is centred on the surface cooking area and that nothing hot is sitting on the touch control panel. Nothing has failed; reposition the pan, clear the controls, and the cooktop carries on.
Error codes
Reference| Code | Meaning |
|---|---|
| F4 | Make sure the pot or pan is centered on the surface cooking area and nothing hot is on the touch control panel. |
Signs that go with the code
- A zone stops or will not start — The control does not see a properly placed pan.
- A pan sits off the zone marking — Off-centre pans are the classic trigger.
- A hot lid, pan or utensil rests near the controls — Heat on the control panel is the other half of the guidance.
- NEAR MISS: a centred, suitable pan never heats on any zone — That is a fault in the zones or the control, not pan placement.
Causes, most likely first
- Pan off-centre on the zone — The most common cause: the pan sits partly outside the zone marking, so the zone cannot couple to it.
- Something hot on the controls — Second: a hot lid, pan or utensil set down on the touch area.
- Pan too small or unsuitable — Third: a base that is too small, warped or not suited to the zone behaves like an off-centre pan.
- Zone sensing fault — Last: if a centred, suitable pan still triggers the code, the zone’s sensing is at fault.
The order to check, and why
- Centre the pan — Line it up with the zone marking.
- Clear and cool the controls — Lift away anything hot from the touch area.
- Try a different pan — A known-good pan rules out the cookware.
- Try another zone — If that works, the first zone may need checking.
Owner steps, with tools and time
- Reposition — Lift the pan and set it down centred on the zone marking.
About 1 min
- Clear the touch area — Move hot lids, pans and utensils off the controls and let the area cool.
About 5 min
- Known-good pan test — Run a pan that works elsewhere, centred on the zone that showed the code.
Tools: induction-ready panAbout 5 min
- STOP here if the next check needs a panel off — Anything behind a panel is a power-off technician job, and the tests that follow it are made on live circuits.
Before you open anything
Safety
Unplug the appliance or switch off its breaker before removing any panel. A capacitor can hold a charge after the power is off. The electronics under the glass run at high voltage and are not owner-serviceable; owner checks stay on top of the glass and at the breaker.
When this is a service call
Call only if a centred, suitable pan still shows F4 with the controls clear and cool, on more than one try. Then the zone’s pan detection or the control under the glass needs checking.
Neighbouring codes
Scope of this reading
The reading above covers Amana electric and induction cooktops with touch controls. It does not cover Amana gas cooktops, Amana ranges, whose surface codes are listed with the oven codes, or sister brands on the same platform, whose lists can read differently. A model-specific page for F4, where one exists, is the more specific answer; none exists yet, so check the use-and-care guide for your exact model before ordering any part.
Browse the code list
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
