The short answer
F1E7 means the brand points at the cooktop control, the board that runs the zones, or its wiring. Try a breaker reset; if the code returns, stop using the cooktop until it is diagnosed, because a faulty control can drop or hold zones unpredictably.
Error codes
Reference| Code | Meaning |
|---|---|
| F1E7 | There may be a problem with the Cooktop Control, or the associated wiring. |
What the cooktop does with the code showing
- Zones do not respond to the keys — The control is not acting on commands.
- Zones switch off or change setting by themselves — An unreliable control.
- The code appears at power-up — The control fails its own start-up check.
- NEAR MISS: only one zone misbehaves — That points at the zone or its own wiring, a different reading.
Likely causes, in order
- Control board failed — The most common cause when the code survives a reset: the board’s components fail with heat and age.
- Loose or heat-damaged connector — Second: a browned or loose connector at the board.
- Heat from poor ventilation — Third: a cooktop installed without its required clearance, or over a crowded drawer, cooks its own control.
- Power event — Last: a surge, ruled out by a clean reset.
Where to start, and what comes next
- Breaker reset — The first step and the cheapest.
- Smell and listen — Burning smells or crackling mean the breaker stays off.
- Check the space under the cooktop — Crowded drawers and blocked vents heat the control.
- Technician tests the control and wiring — Under the glass, with the power off.
What you can safely do
- Breaker reset — Switch the breaker off for a minute, then on, and try one zone.
About 3 min
- Clear the underside — Make sure nothing in the drawer or cabinet below presses against the cooktop.
About 10 min
- Watch the next cook — Note whether the code returns and what was running.
Tools: notepad or phoneAbout 2 min
- STOP here if the next check needs a panel off — Anything behind a panel is a power-off technician job, and the tests that follow it are made on live circuits.
Power off before any panel
Safety
Switch off the cooktop’s breaker before removing it from the counter or opening anything underneath: most cooktops are hard-wired, with no plug to pull. A capacitor can hold a charge after the power is off. Let the glass cool before cleaning or inspecting it.
The point to call
Call when the code returns after a breaker reset, and at once if there is a burning smell. A control fault is diagnosed and fixed under the glass, with the cooktop lifted and the power off.
Other Amana cooktop codes close to this one
Which models this reading covers
Generalized information for Amana electric and induction cooktops with touch controls. It is not a reading for Amana gas cooktops, Amana ranges, whose surface codes are listed with the oven codes, or sister brands on the same platform, whose lists can read differently. The details that change inside the line, such as wiring colours, part numbers and connector locations, belong on model pages, and none is published for F1E7 yet.
All Amana cooktop codes
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
