F1E0 in brief
F1E0 means the control sees one or more keys as permanently pressed, and the brand notes that lights may flash and tones may sound. Usually something on the glass is causing it; clear and dry the controls and it clears, but if it stays on a clean panel, the touch control needs checking.
Error codes
Reference| Code | Meaning |
|---|---|
| F1E0 | This is indicating that one or more keys are permanently pressed. Lights may flash, beeping/audio tones may sound. |
Signs that go with the code
- Lights flash across the controls — The brand lists flashing as part of this code.
- Beeping or tones that will not stop — The control reacting to a press it cannot release.
- One key’s light stays on — That marks the key the control thinks is held.
- NEAR MISS: keys respond but no zone heats — That is a heating or power fault, not a held key.
Causes, most likely first
- Something resting on a key — The most common cause: a utensil, lid, pan handle or towel on the touch area.
- Liquid or residue over the keys — Second: a spill, wiping water or dried soil that the key reads as a finger.
- A key failed on the touch control — Third: if a clean, dry panel still shows the code, the key’s sensor is reporting a constant press.
- Moisture inside the controls — Least likely: water that got under the glass edge or into the module.
The order to check, and why
- Look for the key that stays lit — It tells you where to clean first, and what to report.
- Clear and dry the whole control area — Remove everything, then a soap-and-water clean and a dry pass.
- Breaker reset — Restart the control with the panel clean.
- Leave a key that stays held to a technician — That is the touch control, under the glass.
Owner steps, with tools and time
- Clear and clean — Remove items from the controls, wipe with mild soap and water, then dry thoroughly.
Tools: mild soap, microfiber towelAbout 5 min
- Breaker reset — Switch the breaker off for a minute, then on.
About 2 min
- Identify the key — If the code returns, note which key light stays on or which zone misbehaves.
Tools: notepad or phoneAbout 2 min
- STOP here if the next check needs a panel off — Anything behind a panel is a power-off technician job, and the tests that follow it are made on live circuits.
Before you open anything
Safety
Unplug the appliance or switch off its breaker before removing any panel. A capacitor can hold a charge after the power is off. The electronics under the glass run at high voltage and are not owner-serviceable; owner checks stay on top of the glass and at the breaker.
When this is a service call
Call when the code returns on a clean, dry, empty control panel after a reset, and mention which key stays lit. A key that reads as permanently pressed on its own means the touch control under the glass is faulty, and it is replaced from below with the power off.
Neighbouring codes
Scope of this reading
The reading above covers Amana electric and induction cooktops with touch controls. It does not cover Amana gas cooktops, Amana ranges, whose surface codes are listed with the oven codes, or sister brands on the same platform, whose lists can read differently. A model-specific page for F1E0, where one exists, is the more specific answer; none exists yet, so check the use-and-care guide for your exact model before ordering any part.
Browse the code list
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
