The short answer
F0 means the cooktop sees constant pressure on its control panel from an object, liquid or soil. Nothing has failed: clear and dry the controls, wait a moment, and the code should clear; the cooktop is safe to use once it does.
Error codes
Reference| Code | Meaning |
|---|---|
| F0 | An object, liquids, or soils are putting pressure on the control panel. |
What the cooktop does with the code showing
- Beeping and a flashing display — The control reacting to a press that never ends.
- Zones switch off by themselves — Many controls shut down to stay safe when keys appear held.
- A pan, lid or utensil sits on or near the controls — Even a light object reads as a finger.
- NEAR MISS: the code stays with the panel clean and dry — Then it is no longer pressure from outside; the touch module is suspect.
Likely causes, in order
- Object on the control panel — The most common cause: a pan handle, lid, utensil or towel resting on the touch area.
- Liquid on the touch area — Second: spills and cleaning water on the glass over the keys.
- Dried soil or residue film — Third: a layer of cooked-on residue that the sensors read as constant contact.
- Touch module fault — Least likely: a module that reports pressure on a clean, dry panel has failed.
Where to start, and what comes next
- Clear the control area — Remove anything on or touching the touch keys.
- Clean and dry the panel — Soap and water on a soft cloth, then a dry microfiber pass.
- Wait, then retry — Give the control a moment to see the panel clear.
- Breaker reset if it persists — One reset after cleaning separates residue from a fault.
What you can safely do
- Remove objects — Lift pans, lids, utensils and towels away from the touch area.
About 1 min
- Clean the touch area — Wipe with mild soap and water, then dry thoroughly with a microfiber towel.
Tools: mild soap, microfiber towelAbout 5 min
- Lock the controls while cleaning — Use the control lock, if your model has one, so wiping does not register as presses.
About 1 min
- STOP here if the next check needs a panel off — Anything behind a panel is a power-off technician job, and the tests that follow it are made on live circuits.
Power off before any panel
Safety
Switch off the cooktop’s breaker before removing it from the counter or opening anything underneath: most cooktops are hard-wired, with no plug to pull. A capacitor can hold a charge after the power is off. Let the glass cool before cleaning or inspecting it.
The point to call
Call only when the code stays on a clean, dry, empty control panel after a breaker reset. At that point the touch module is reporting presses that are not there, which is a part replacement under the glass.
Neighbouring codes
Scope of this reading
The reading above covers Amana electric and induction cooktops with touch controls. It does not cover Amana gas cooktops, Amana ranges, whose surface codes are listed with the oven codes, or sister brands on the same platform, whose lists can read differently. A model-specific page for F0, where one exists, is the more specific answer; none exists yet, so check the use-and-care guide for your exact model before ordering any part.
Browse the code list
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
