GE Dishwasher Not Draining? Expert GE Repair

Why GE Dishwashers Experience This

Related GE Error Codes

Seeing one of these codes? It likely indicates not draining.

Diagnostic Steps for GE Dishwasher

1. 1

   Remove lower spray arm and filter assembly — inspect sump area for broken glass, food debris, or mineral scale

2. 2

   Test drain solenoid (older models): measure coil resistance — should read 30-50 ohms; infinite means open coil requiring replacement

3. 3

   Check disposal knockout plug: disconnect drain hose from disposal, look inside disposal inlet with flashlight — if blocked by plastic disc, punch out with screwdriver and remove debris

4. 4

   Run GE dishwasher diagnostic: close door, press Start + Select 3 times within 5 seconds, then Start — unit runs test drain cycle

What the Repair Involves

The technician inspects the sump area and drain path first. On older models with drain solenoids, the solenoid is replaced on the valve assembly — a 25-minute repair. On newer models with direct-drive drain pumps, the pump motor assembly is accessed from underneath. The technician also verifies the disposal connection is clear and the air gap is functioning. Most GE dishwasher drain repairs complete in 30-45 minutes.