Want a regional phone & address? Pick your area.
Maytag·Washermedium severity
Maytag Washer Error Code F5 E1
Door or lid will not lock
Common Causes
- 1Failed lid-lock striker or latch assembly
- 2Bent or missing lid strike catching the lock
- 3Lock solenoid coil open
- 4Harness break between the lock and the control
Step-by-Step Troubleshooting
- 1
Watch and listen at cycle start: on a Bravos or Centennial top-loader the lid lock should click and its light stop flashing within a few seconds of pressing Start
- 2
Inspect the plastic lid strike that drops into the lock body for a crack or a bent tab that stops the latch from seating
- 3
On a Maxima front-loader push the door firmly until the catch clicks, then check the hinge has not sagged and dropped the strike below the lock
- 4
Unplug the lock connector and read the solenoid coil for continuity, treating an open reading as a failed lock rather than a control fault
- 5
Flex the lock harness where it enters the tub to expose an intermittent break before you order the lock assembly
Pro Diagnostic Tip
The Maytag top-load lid lock is a frequent wear item because it cycles on every load and its plastic strike fatigues; if the machine hums but never fills or spins, the lock never confirmed closed. Replace the whole lock module rather than the striker alone, since the microswitch inside wears at the same rate.
You Might Also Notice
- •The lid-locked light blinks and the cycle never starts
- •The washer fills but will not advance to spin
- •An audible click is missing at the start of the cycle
- •The lid feels loose or the strike wobbles
Parts, Cost & Difficulty
Repair Difficulty
Moderate — Some Experience NeededEstimated Repair Cost
$130–$300
Parts + labor. Free diagnosis with repair.
Parts That May Need Replacement
Lid-lock / door-lock assemblyLid strike
Do You Have the Right Tools?
Bearing puller set ($120), drum spider wrench ($85), multimeter ($85), and diagnostic software. Our technician arrives with $3,000+ in professional tools — your diagnostic is free.
Book a Free Diagnostic VisitOr call for a free consultation (415) 795-7300Available 24/7 — call or text
Licensed & Insured · 90-Day Warranty · Same-Day Service
Safety First — Know the Risks
High-voltage components and pressurized water lines create flood and shock risk. A single loose fitting can cause thousands in water damage. Our techs are licensed and insured — let them handle the risk.
Let a Licensed Pro Handle ItOr call for a free consultation (415) 795-7300Available 24/7 — call or text
Licensed & Insured · 90-Day Warranty · Same-Day Service
Ready to Get This Fixed?
Don't let error code F5 E1 disrupt your day. A professional diagnosis takes about 30 minutes — and it's free when you proceed with the repair.
Licensed & Insured · 90-Day Warranty · Same-Day Appointments Available
5.00 (36 verified reviews)
Same-Day Appliance Repair
Fixed or It's Free
Free Service Call & Diagnosis — no hidden fees, offer ends Sep 15
Book a Free Diagnostic VisitOr call (415) 795-7300Available 24/7 — call or text
Frequently Asked Questions
What does Maytag error code F5 E1 mean?
Maytag error code F5 E1 indicates: Door or lid will not lock. This is a medium-severity issue affecting your washer.
How do I fix Maytag error code F5 E1?
Watch and listen at cycle start: on a Bravos or Centennial top-loader the lid lock should click and its light stop flashing within a few seconds of pressing Start Then, Inspect the plastic lid strike that drops into the lock body for a crack or a bent tab that stops the latch from seating Then, On a Maxima front-loader push the door firmly until the catch clicks, then check the hinge has not sagged and dropped the strike below the lock There are 2 more steps — see the full troubleshooting guide above. This repair typically requires professional tools and expertise.
How do I know if my washer has error F5 E1?
Besides the error code on the display, common signs include: The lid-locked light blinks and the cycle never starts; The washer fills but will not advance to spin; An audible click is missing at the start of the cycle. If you notice any of these symptoms, check your washer's display panel for error code F5 E1.
How much does it cost to fix Maytag F5 E1?
Repair costs for Maytag F5 E1 typically range from $130 to $300 depending on the specific cause and parts needed. EasyBear offers free diagnosis when you proceed with the repair. Call (415) 795-7300 for a same-day appointment.
Call NowAvailable 24/7 — call or textBook Online