F10E4 explained
Maytag gives F10E4 a potential cause: a diverter valve error. The diverter routes wash water to the different spray arms in turn, and the code means the control has doubts about it. A blocked filter or sump can be cleared by an owner, but if F10E4 keeps returning, the diverter or its motor, switch or wiring is repaired from underneath the tub. Knowing what that involves helps you plan: the dishwasher usually has to be eased out of its space, with the water and power isolated first. A clean filter is worth checking first, because it costs nothing.
Error codes
Reference| Code | Meaning |
|---|---|
| F10E4 | Potential Cause: Diverter Valve Error |
Signs that come with F10E4
- Patchy results across the racks — Water is not being shared between the arms as it should be.
- A cycle that stops early with the code — The control halts the programme when it doubts the diverter.
- A brief motor hum followed by quiet as the wash begins — The diverter motor may be trying, and failing, to move.
- The code returns after every reset — The fault has not cleared itself.
- Food scraps or glass in the sump — Debris can stop the diverter turning.
Ranked causes of F10E4
- Debris in the diverter — First: hard bits that slip past the filter can jam the valve.
- A worn diverter motor — Second: it turns many times every cycle and wears.
- A faulty position switch — Third: the motor may turn while its position is misreported.
- Wiring or the control — Fourth: a loose plug under the tub, or the board itself.
Before you book
- Reset once — Switch off at the breaker for a few minutes.
- Clean the filter and the sump — Remove anything hard you find.
- Run a rinse cycle — Watch whether F10E4 returns.
- Note how the racks wash — Uneven results support the code.
- Check access around the dishwasher — The repair is easier if the space in front and the sink cabinet are clear.
- Look at the floor in front — A clear stretch of flooring lets the dishwasher be eased out without scratching or lifting it.
Owner steps for F10E4
- Reset at the breaker — Off for a few minutes, then on.
About 5 min
- Clean the filter and the sump — Wearing gloves, lift out debris and rinse the filter.
Tools: gloves, soft brushAbout 15 min
- Run a rinse and watch — See whether the code comes back.
About 20 min
- Clear the sink cabinet and the floor in front — The repair needs the water valve within reach and room to ease the dishwasher out.
About 10 min
- Leave the diverter to a professional — It is reached from below with the power and water isolated.
Tools: ::
Safety around a diverter repair
Switch off at the breaker before reaching into the sump, and wear gloves because broken glass collects there. Let water from a hot cycle cool first. Do not slide the dishwasher out yourself: it is connected to water, drain and power, and the floor beneath may be wet. Never bypass the door switch. The kick plate hides electronics that may still be charged, so keep it fitted.
When F10E4 needs a professional
Book a repair if F10E4 returns after the filter and the sump are clean. Expect the visit to include isolating the water and power, easing the dishwasher forward or out, and testing the diverter motor, its switch and the wiring before anything is replaced. If new flooring was laid after the dishwasher went in, mention it, because the machine may be boxed in and need extra care to remove.
Dishwashers covered
Maytag built-in dishwashers showing F10E4 are covered here. It does not cover other Maytag appliances or other brands. No model-specific F10E4 page has been published; diverter designs and access differ between models, so check your model's documentation.

