FAE5 explained
Jenn-Air lists the potential cause of FAE5 as a diverter leak: water escaping at the valve that routes it to the spray arms, where it should be held. Escaped water tends to end up in the base of the dishwasher, under the tub, and many machines react to water there by stopping or pumping out. Switch the dishwasher off, check the floor, let the base dry out, and look at the usual suspects before anything is replaced.
Error codes
Reference| Code | Meaning |
|---|---|
| FAE5 | Potential Cause: Diverter Leak |
Signs that come with FAE5
- The drain pump runs when no cycle is draining — Many machines empty the tub when they sense water underneath, which limits the leak.
- A wet floor near the hinges or the toe panel — Water collected underneath can seep out at the front.
- Cycles that stop with water left in the tub — The control halts the programme when it suspects a leak.
- More foam than usual inside the door — Excess suds push water past seals and are an easy fix.
- A musty smell from the base — Water that sits under the tub for days can leave a damp smell near the toe panel.
Causes of FAE5, ranked
- A worn seal at the diverter — First: the seal works in hot, detergent-laden water every cycle and eventually stops sealing.
- Excess suds — Second: hand-washing liquid, too much detergent or an overfilled rinse aid dispenser makes foam that forces water past seals.
- Debris holding the diverter open — Third: fragments caught in the valve stop it closing fully.
- A cracked diverter housing — Fourth: a crack leaks every cycle and will not respond to cleaning.
What to check first
- Stop the cycle and switch off — Do this before mopping or kneeling near the base.
- Look for suds — Foam inside the door or tub points to a detergent problem.
- Check the floor and toe panel area — Note where the water appears.
- Inspect the filter area — Remove debris that could hold the diverter open.
- Check the detergent you use — Hand-washing liquid, or a generous scoop of powder, is enough to fill the tub with foam.
Owner steps for FAE5
- Switch off at the breaker and mop up — Dry the floor in front of and around the dishwasher.
Tools: towelsAbout 10 min
- Let the base dry — Leave the door ajar overnight with the power off so trapped water can evaporate.
Tools: ::
- Clear the suds — If foam is present, run a rinse without detergent once the base is dry.
About 20 min
- Clean the filter and sump — Remove debris near the diverter.
Tools: soft brush, tongsAbout 15 min
- Stop before the toe panel — Replacing a diverter seal or housing means working beneath the tub with water and power off, which needs a professional.
Tools: ::
Water and power
Switch the dishwasher off at its breaker before mopping or reaching under the front, because water and mains wiring meet near the base. Do not tilt or lift the dishwasher to drain it. The heater and the water inside can stay hot after a cycle. Leave the panels closed; the electronics behind them can hold a charge.
When FAE5 needs a professional
Get help if FAE5 returns with a dry base and the correct detergent, if water reaches the floor again, or if the drain pump keeps running. A professional replaces the diverter seal or housing from below the tub. Say whether the floor was wet and whether foam was present, because that decides whether the visit starts with the seal or the detergent.
Neighbouring dishwasher codes
Which dishwashers this covers
This reading covers Jenn-Air built-in dishwashers that list FAE5. It does not cover other Jenn-Air appliances or sister brands, whose lists may differ. No model-specific FAE5 page exists yet; diverter and base designs vary, so check the documentation for your model.

