What is the Frigidaire Washer E35 error?#
E35 means your Frigidaire washer has detected the water level above its maximum — an overfill condition. The machine reads this through a pressure switch connected by a thin hose to the tub, so E35 is usually about that sensing system misreporting, or an inlet valve that will not shut off, rather than a literal flood every time. It is worth taking seriously because true overfilling can leak, so confirm what is happening before you run another load.
E35 on a Frigidaire Washer: likely causes and repair cost#
On a Frigidaire Washer, the E35 code signals: water level above maximum.
| Likely cause | Typical likelihood |
|---|---|
| Pressure switch failure | Most common |
| Air trap blockage | Common |
| Water inlet valve stuck open | Less common |
Typical professional repair: $125–$275 · Difficulty: hard · usually a technician job
Symptoms that often accompany E35: Water overflowing from tub; Washer fills continuously; Water on floor around washer
Technician diagnostic sequence for E35:
- Immediately unplug washer and turn off water supply valves
- Blow gently into the pressure switch hose — listen for a click from the switch
- Inspect air trap at bottom of tub for detergent buildup or debris
- Check if water continues entering with power off — if yes, inlet valve is stuck
Parts a technician may check or replace: pressure switch; water inlet valve
Field note: Blow gently into the pressure switch hose — you should hear a click. No click = failed switch. If switch clicks but E35 persists, the air trap is blocked with detergent residue.
Safety note: Flood risk. Turn off water supply valves immediately. A stuck inlet valve can flood the laundry area within minutes.
Do You Have the Right Tools?
Bearing puller set ($120), drum spider wrench ($85), multimeter ($85), and diagnostic software. Our technician arrives with $3,000+ in professional tools — your diagnostic is free.
Licensed & Insured · 90-Day Warranty · Same-Day Service
How to troubleshoot the E35 error yourself#
Look at the sensing and the fill. First, check whether the tub is actually overfilling or the machine just thinks so — if the water level looks normal, the fault is in the sensing system. Pull the washer out, find the clear pressure hose that runs from the tub to the pressure switch, and check it for kinks, cracks, or trapped water and debris, since a blocked air dome or hose gives a false high reading. If the tub genuinely overfills and water keeps coming even when the machine should be done filling, the water inlet valve is stuck open and must be replaced. Reseating or clearing the pressure hose is a reasonable DIY step; testing the pressure switch and replacing a stuck inlet valve is where I bring in a technician.
Is the Frigidaire Washer E35 error worth fixing?#
An E35 repair runs $125 to $275, covering the pressure switch, a fouled pressure hose, or a stuck inlet valve depending on the cause. That is a comfortable margin below the cost of a new Frigidaire washer, so on a sound machine the fix is worth it — an overfill fault left alone risks leaks and water damage. I would only weigh replacement on an older washer where this repair would join several others climbing toward half the price of a new unit.
Safety First — Know the Risks
High-voltage components and pressurized water lines create flood and shock risk. A single loose fitting can cause thousands in water damage. Our techs are licensed and insured — let them handle the risk.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Frigidaire Washer E35: frequently asked questions#
What does the E35 error mean on a Frigidaire washer?#
E35 means the control has sensed the water level above maximum — an overfill. It usually stops the cycle to prevent leaking.
Is it safe to keep using a Frigidaire washer showing E35?#
Be cautious — if the tub truly overfills, running it risks leaks and water damage. Confirm the cause before using it again.
Can I clear the E35 error myself?#
Sometimes. Clearing or reseating the pressure hose and its air dome can fix a false reading. A failed pressure switch or a stuck inlet valve needs a technician.
How much does it cost to repair E35 on a Frigidaire washer?#
A professional repair typically runs $125 to $275, depending on whether it is the pressure switch, hose, or inlet valve.
Which parts usually fail when a washer throws E35?#
The pressure switch and its sensing hose are common, along with a water inlet valve that sticks open and overfills the tub.
Why does a pressure switch failure trigger the E35 error?#
The pressure switch reports the water level to the control. If it fails or its hose is blocked, it can signal a level above maximum even when filling is normal, and the control reports E35.
Is a Frigidaire washer with E35 worth repairing?#
For a sound machine, yes — a $125 to $275 repair prevents leaks for far less than a new washer.
Appliance Repair Technician · 11 years experience
Experienced technician with 11 years specializing in Frigidaire and Electrolux refrigerator and dryer repair with a focus on safety.
