How much does a dryer gas valve coils replacement cost?#
A gas valve coils replacement on a dryer usually costs $115 to $210, with the everyday bill close to $163. Where your quote falls comes down to a few levers: an aftermarket part keeps the gas coils affordable, while an original component, tight access, or a premium LG name pushes it higher. Labor weighs as heavily as the part itself: a layout that lets a tech get at the valve coils quickly bills less time than one that forces a full strip-down of the unit. In practice the fix is quick once the fault is confirmed: the old coils comes out, the replacement goes in, and a full test cycle proves the unit is back to normal. The table under this answer lays out the part-plus-labor math behind that figure. Weighed beside the $450 to $1,300 of buying new, the repair earns its keep unless the dryer is already near the end of the road.
Dryer gas valve coils replacement cost
- What it does: the gas valve coils opens the gas valve so the burner lights.
- Signs it is failing: a burner that will not stay lit or short heat cycles.
- The repair job: testing the coils and replacing the coil set.
- DIY or pro: a moderate DIY job on a gas unit if you are careful.
| What you pay for | Typical cost |
|---|---|
| Part plus basic labor | $115 |
| Typical repair | $163 |
| Premium part or hard access | $210 |
| A new dryer, installed | $450–$1,300 |
Against a new dryer at $450–$1,300 installed, a gas valve coils repair at $115–$210 is usually the cheaper fix — unless the dryer is already old or has other faults.
Pro note: a tech tests both coils together, since one weak coil intermittently drops the flame and fakes a bigger fault.
Is replacing the gas valve coils on a dryer worth it?#
If the machine is newer, the answer is an easy yes: the $115 to $210 outlay is far below the $450 to $1,300 a fresh dryer would cost, and the repair leaves the rest of the machine untouched. The decision tightens on an older unit. Once the dryer carries other tired parts and this job climbs toward $210, you are pouring real money into a machine that may need more soon — and a new dryer starts to make sense. In short, the repair pays on a healthy unit, and a licensed tech can confirm the coils is the real culprit before you spend a dollar on parts. Booking a pro means the coils is diagnosed right the first time and the repair carries a written guarantee, which matters most on a part buried this deep.
Do You Have the Right Tools?
Gas leak detector ($130), thermal fuse tester ($95), belt tension gauge, and vent inspection camera ($180). Our technician arrives with $3,000+ in professional tools — your diagnostic is free.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Dryer Gas valve coils replacement cost: FAQ#
How much does a dryer gas valve coils replacement cost?#
A dryer coils replacement generally runs $115–$210, and about $163 on a routine job. Part grade, brand, and how hard the gas coils is to reach are what set where you land.
Is replacing the coils worth it, or should I just buy new?#
Usually worth it on a machine that is not too old — $115 to $210 is minor next to the $450 to $1,300 of buying new. Replacement only wins once the unit is aging and other repairs are stacking up behind this one.
What makes the valve coils fail?#
Common causes are sediment and mineral buildup that jams the mechanism, plus ordinary wear on the seals. The warning signs to watch for are a burner that will not stay lit or short heat cycles.
Can I replace the coils myself?#
A confident DIYer can often manage it when the coils is easy to reach and the diagnosis is solid. If any of that is in doubt, a pro removes the guesswork and warranties the repair.
How long does the job take?#
Plan on the better part of an afternoon for the swap itself, plus a test cycle afterward to confirm the fault is cleared. A tech who has done it before tends to work at the fast end of that estimate.
