Want a regional phone & address? Pick your area.
Maytag·Dishwashermedium severity
Maytag Dishwasher Error Code F6 E4
Water flow meter error
Common Causes
- 1Flow meter failure
- 2Turbine blockage in flow meter
- 3Wiring fault
Step-by-Step Troubleshooting
- 1
Locate the flow meter on the inlet side of the wash system — it measures water volume entering the tub
- 2
Check the flow meter connector for corrosion or loose pins
- 3
Test the flow meter: it should produce a pulsing signal when water flows — use a multimeter on AC mode
- 4
Inspect for debris in the flow meter that could block the internal turbine wheel
- 5
If the flow meter is clear and connected, replace the sensor
Pro Diagnostic Tip
The flow meter provides precise water measurement. A failed meter causes the dishwasher to either overfill (stuck reading no flow) or underfill (stuck reading full flow). Hard water deposits on the internal turbine wheel are the primary failure mode — common in Sacramento and Bay Area homes.
You Might Also Notice
- •Dishwasher overfills or underfills
- •Error appears during the fill portion of the cycle
- •Water level inconsistent between cycles
- •Dishes not cleaning well due to low water level
Parts, Cost & Difficulty
Repair Difficulty
Moderate — Some Experience NeededEstimated Repair Cost
$100–$225
Parts + labor. Free diagnosis with repair.
Parts That May Need Replacement
WPW10467290 Flow Meter SensorW10854426 Flow Meter Harness
Do You Have the Right Tools?
Bearing puller set ($120), drum spider wrench ($85), multimeter ($85), and diagnostic software. Our technician arrives with $15K+ in professional tools — your diagnostic is free.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Safety First — Know the Risks
High-voltage components and pressurized water lines create flood and shock risk. A single loose fitting can cause thousands in water damage. Our techs are licensed and insured — let them handle the risk.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Ready to Get This Fixed?
Don't let error code F6 E4 disrupt your day. A professional diagnosis takes about 30 minutes — and it's free when you proceed with the repair.
Licensed & Insured · 90-Day Warranty · Same-Day Appointments Available
4.85 (232 verified reviews)
Same-Day Appliance Repair
Fixed or It's Free
Free Service Call & Diagnosis — no hidden fees, offer ends May 31
Frequently Asked Questions
What does Maytag error code F6 E4 mean?
Maytag error code F6 E4 indicates: Water flow meter error. This is a medium-severity issue affecting your dishwasher.
How do I fix Maytag error code F6 E4?
Locate the flow meter on the inlet side of the wash system — it measures water volume entering the tub Then, Check the flow meter connector for corrosion or loose pins Then, Test the flow meter: it should produce a pulsing signal when water flows — use a multimeter on AC mode There are 2 more steps — see the full troubleshooting guide above. This repair typically requires professional tools and expertise.
How do I know if my dishwasher has error F6 E4?
Besides the error code on the display, common signs include: Dishwasher overfills or underfills; Error appears during the fill portion of the cycle; Water level inconsistent between cycles. If you notice any of these symptoms, check your dishwasher's display panel for error code F6 E4.
How much does it cost to fix Maytag F6 E4?
Repair costs for Maytag F6 E4 typically range from $100 to $225 depending on the specific cause and parts needed. EasyBear offers free diagnosis when you proceed with the repair. Call (415) 795-7300 for a same-day appointment.