Want a regional phone & address? Pick your area.
Kenmore·Dishwashermedium severity
Kenmore Dishwasher Error Code F6E1
Water not filling
Common Causes
- 1Supply valve closed
- 2Inlet valve failure
- 3Float switch stuck in up position
Step-by-Step Troubleshooting
- 1
Verify the supply valve under the sink is fully open
- 2
Check for kinks in the supply line
- 3
Open door and press down on the float in the bottom of the tub — if stuck, free it
- 4
If float moves freely and valve is open, the inlet valve solenoid has failed
Pro Diagnostic Tip
Applies to models starting with 665.xxxxx (Whirlpool platform). A stuck float switch is the most common cause after a debris-heavy wash — food particles get under the float dome. Clean the float area.
You Might Also Notice
- •Dishwasher runs dry with no water
- •Cycle starts then stops immediately
- •Banging from spray arms with no water
Parts, Cost & Difficulty
Repair Difficulty
Moderate — Some Experience NeededEstimated Repair Cost
$75–$200
Parts + labor. Free diagnosis with repair.
Parts That May Need Replacement
W10316814 water inlet valve
Do You Have the Right Tools?
Bearing puller set ($120), drum spider wrench ($85), multimeter ($85), and diagnostic software. Our technician arrives with $15K+ in professional tools — your diagnostic is free.
Licensed & Insured · 90-Day Warranty · Same-Day Service
What This Repair Involves
Here's what a professional technician does to resolve this issue:
Check water supply valve under sink
This repair requires bearing pullers, drum spider wrenches, and diagnostic software for control board calibration. Most homeowners find it safer and more cost-effective to have a licensed technician handle it.
Safety First — Know the Risks
High-voltage components and pressurized water lines create flood and shock risk. A single loose fitting can cause thousands in water damage. Our techs are licensed and insured — let them handle the risk.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Ready to Get This Fixed?
Don't let error code F6E1 disrupt your day. A professional diagnosis takes about 30 minutes — and it's free when you proceed with the repair.
Licensed & Insured · 90-Day Warranty · Same-Day Appointments Available
4.85 (232 verified reviews)
Same-Day Appliance Repair
Fixed or It's Free
Free Service Call & Diagnosis — no hidden fees, offer ends May 31
Frequently Asked Questions
What does Kenmore error code F6E1 mean?
Kenmore error code F6E1 indicates: Water not filling. This is a medium-severity issue affecting your dishwasher.
How do I fix Kenmore error code F6E1?
Verify the supply valve under the sink is fully open Then, Check for kinks in the supply line Then, Open door and press down on the float in the bottom of the tub — if stuck, free it There are 1 more steps — see the full troubleshooting guide above. If these steps don't resolve the error, contact a professional.
How do I know if my dishwasher has error F6E1?
Besides the error code on the display, common signs include: Dishwasher runs dry with no water; Cycle starts then stops immediately; Banging from spray arms with no water. If you notice any of these symptoms, check your dishwasher's display panel for error code F6E1.
How much does it cost to fix Kenmore F6E1?
Repair costs for Kenmore F6E1 typically range from $75 to $200 depending on the specific cause and parts needed. EasyBear offers free diagnosis when you proceed with the repair. Call (415) 795-7300 for a same-day appointment.