Want a regional phone & address? Pick your area.
Beko·Dishwasherlow severity
Beko Dishwasher Error Code E05
Temperature sensor (NTC) fault
Common Causes
- 1NTC sensor open or shorted
- 2Sensor wiring damaged
- 3Connector corroded in the damp sump area
Step-by-Step Troubleshooting
- 1
Unplug the dishwasher and access the sump/heater area from the base
- 2
Locate the NTC temperature sensor near the flow-through heater
- 3
Measure the sensor resistance cold — an open or near-zero reading indicates failure
- 4
Inspect the sensor connector for corrosion from long-term moisture exposure
- 5
Replace the NTC sensor if out of range and reseat a clean connector
Pro Diagnostic Tip
Because the NTC sits in the humid sump, a green-corroded connector pin is a more common E05 cause than the sensor itself — clean and reseat before replacing.
You Might Also Notice
- •Cycle time varies oddly run to run
- •Water too hot or never hot
- •Intermittent error clearing on restart
Parts, Cost & Difficulty
Repair Difficulty
Moderate — Some Experience NeededEstimated Repair Cost
$80–$180
Parts + labor. Free diagnosis with repair.
Parts That May Need Replacement
NTC temperature sensor
Do You Have the Right Tools?
Bearing puller set ($120), drum spider wrench ($85), multimeter ($85), and diagnostic software. Our technician arrives with $3,000+ in professional tools — your diagnostic is free.
Book a Free Diagnostic VisitOr call for a free consultation (415) 795-7300Available 24/7 — call or text
Licensed & Insured · 90-Day Warranty · Same-Day Service
Safety First — Know the Risks
High-voltage components and pressurized water lines create flood and shock risk. A single loose fitting can cause thousands in water damage. Our techs are licensed and insured — let them handle the risk.
Let a Licensed Pro Handle ItOr call for a free consultation (415) 795-7300Available 24/7 — call or text
Licensed & Insured · 90-Day Warranty · Same-Day Service
Ready to Get This Fixed?
Don't let error code E05 disrupt your day. A professional diagnosis takes about 30 minutes — and it's free when you proceed with the repair.
Licensed & Insured · 90-Day Warranty · Same-Day Appointments Available
5.00 (36 verified reviews)
Same-Day Appliance Repair
Fixed or It's Free
Free Service Call & Diagnosis — no hidden fees, offer ends Sep 15
Book a Free Diagnostic VisitOr call (415) 795-7300Available 24/7 — call or text
Frequently Asked Questions
What does Beko error code E05 mean?
Beko error code E05 indicates: Temperature sensor (NTC) fault. This is a low-severity issue affecting your dishwasher.
How do I fix Beko error code E05?
Unplug the dishwasher and access the sump/heater area from the base Then, Locate the NTC temperature sensor near the flow-through heater Then, Measure the sensor resistance cold — an open or near-zero reading indicates failure There are 2 more steps — see the full troubleshooting guide above. This repair typically requires professional tools and expertise.
How do I know if my dishwasher has error E05?
Besides the error code on the display, common signs include: Cycle time varies oddly run to run; Water too hot or never hot; Intermittent error clearing on restart. If you notice any of these symptoms, check your dishwasher's display panel for error code E05.
How much does it cost to fix Beko E05?
Repair costs for Beko E05 typically range from $80 to $180 depending on the specific cause and parts needed. EasyBear offers free diagnosis when you proceed with the repair. Call (415) 795-7300 for a same-day appointment.
Call NowAvailable 24/7 — call or textBook Online