How much does a washer dryer combo motor replacement cost?#
Replacing the motor in a washer dryer combo typically runs $250 to $560, and a routine job lands around $405. Where your quote falls comes down to a few levers: an aftermarket part keeps the motor assembly affordable, while an original component, tight access, or a premium GE name pushes it higher. Much of the price is the reach — some designs surrender the motor in minutes, others demand the combo come most of the way apart first. Expect the technician to verify the symptom, rule out the cheaper look-alike faults, and only then replace the motor — that discipline is what stops you paying for the wrong part. The breakdown just below separates the part price from the labor so you can see which side of the $250 to $560 spread a given estimate sits on. Set against the $1,000 to $2,500 a new washer dryer combo costs to buy and install, restoring the drive motor is the economical move on any machine with good years left in it.
Washer Dryer Combo motor replacement cost
- What it does: the motor turns the drum or tub.
- Signs it is failing: a drum that will not move, humming, or a burning smell.
- The repair job: testing the windings, fitting a new motor, and checking the belt or coupler.
- DIY or pro: usually a technician job.
| What you pay for | Typical cost |
|---|---|
| Part plus basic labor | $250 |
| Typical repair | $405 |
| Premium part or hard access | $560 |
| A new washer dryer combo, installed | $1,000–$2,500 |
Against a new washer dryer combo at $1,000–$2,500 installed, a motor repair at $250–$560 is usually the cheaper fix — unless the washer dryer combo is already old or has other faults.
Pro note: a tech confirms the motor is truly dead and not a seized bearing or a snapped belt faking it, since those cost far less.
Is replacing the motor on a washer dryer combo worth it?#
On a reasonably young unit, $250 to $560 to restore the motor assembly beats the $1,000 to $2,500 of buying new without much debate; the fix buys years more use from a machine that is otherwise sound. Age shifts the math. When the motor is the third thing to fail this year, or the unit is well past 8 years, a top-of-range $560 bill is better put toward a replacement than a patch. Rule of thumb — restore a sound machine, and think hard before spending the high end of that range on one already worn out. When you are ready, an EasyBear technician can confirm the diagnosis on the first visit and give a firm price on the drive motor, diagnostic included.
Do You Have the Right Tools?
Bearing puller set ($120), drum spider wrench ($85), multimeter ($85), and diagnostic software. Our technician arrives with $3,000+ in professional tools — your diagnostic is free.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Washer Dryer Combo Motor replacement cost: FAQ#
How much does a washer dryer combo motor replacement cost?#
A washer dryer combo drive motor replacement generally runs $250–$560, and about $405 on a routine job. Part grade, brand, and how hard the motor assembly is to reach are what set where you land.
Is replacing the drive motor worth it, or should I just buy new?#
Usually worth it on a machine that is not too old — $250 to $560 is minor next to the $1,000 to $2,500 of buying new. Replacement only wins once the combo is aging and other repairs are stacking up behind this one.
What makes the motor fail?#
Common causes are worn bearings, an overloaded circuit, and water or lint working into the windings. The warning signs to watch for are a drum that will not move, humming, or a burning smell.
Can I replace the drive motor myself?#
Most owners leave this one to a pro: reaching the drive motor and confirming the diagnosis takes the right tools, and a wrong part is money down the drain. A technician also carries the exact component and stands behind the work.
How long does the job take?#
Plan on a couple of hours for the swap itself, plus a test cycle afterward to confirm the fault is cleared. A tech who has done it before tends to work at the fast end of that estimate.
Senior Appliance Repair Technician · 15 years experience
EPA-certified technician with 15 years of experience specializing in refrigerator and cooling system repairs.


