Amana Refrigerator Ice Maker Not Working — Solved

Ice maker not working on an Amana refrigerator rarely comes out of nowhere — a specific part or condition is behind it, and pinning that down turns a guess into a real fix.

The short answer#

Most likely: clogged or expired water filter. Amana uses Whirlpool-compatible filters; expired filters restrict flow below the minimum 40 PSI required for ice maker fill If that checks out, look next at ice maker module motor burnout (w10190961).

Safety first#

For gas appliances, turn off the gas supply valve as well.

Causes, ranked by likelihood#

Here is how the causes stack up, most common first:

Working through it yourself#

Move through these in order — the first match is usually the fix.

1. Clogged or expired water filter#

In practice, amana uses Whirlpool-compatible filters; expired filters restrict flow below the minimum 40 PSI required for ice maker fill Pull and clean the filter; a clogged one chokes airflow and is the first thing to rule out.

2. Ice maker module motor burnout (W10190961)#

stripped gears prevent the ejector arms from cycling and harvesting ice from the mold Reseat the board’s connectors and inspect for burned relays; board faults usually need a replacement, not a repair.

3. Frozen water fill tube#

Mechanically, the tube feeding water to the ice maker tray freezes solid, blocking all water delivery; thaw with warm water as a diagnostic step Our field data from Amana repairs confirms frozen water fill tube drives most complaints of this nature that we diagnose. Inspect the seal or hose for cracks, tears, or a loose clamp where water can escape.

4. Water inlet valve failure (Whirlpool W10408179)#

the ice maker solenoid in the dual valve fails independently of the dispenser port; typical after 7-10 years on Amana side-by-sides With power off, verify the valve opens and closes — a stuck valve is a common, low-cost fix.

5. Freezer temperature too warm#

The short version: the ice maker thermostat will not trigger a fill cycle if the freezer is above 5 degrees F; inspect for cooling issues if ice production drops With the unit unplugged, inspect this part for visible wear or a loose connection and test it before replacing.

6. Amana refrigerator ice maker not filling with water — why?#

(2) Water filter is expired and restricting flow. (3) Fill tube behind the ice maker is frozen — feel the tube; if it is solid ice, thaw with warm water. No water reaching the ice maker means either: (1) Water supply valve under the sink is closed or partially closed. Rule it in or out with a visual check and a continuity test where possible.

Models this commonly hits#

We see this reported most on Amana models such as ASI2575GRS, ASD2575BRS, ABB1921BRW, though the diagnosis above applies across the refrigerator lineup.

The short checklist#

Here is the whole diagnosis on one line each:

• Clogged or expired water filter — most common; clear the filter and vent path fully — restricted airflow drives many of these symptoms.
• Ice maker module motor burnout (W10190961) — common; try a hard reset first — unplug for a minute — then look for scorched spots or swollen parts on the board.
• Frozen water fill tube — fairly common; run a short cycle and watch where it drips — that pinpoints the failed seal or connection.
• Water inlet valve failure (Whirlpool W10408179) — occasional; check that the valve or flap moves freely and isn’t stuck.
• Freezer temperature too warm — less common; rule it in or out with a visual check and a continuity test where possible.

What fixing it usually involves#

The repair path is predictable: diagnose, access, replace, and verify. A tech confirms the clogged or expired water filter or works down the list, fits the right part, and runs a cycle to be sure it holds.

Keeping it from coming back#

A little routine care goes a long way: keep the refrigerator clean, level, and free of buildup, and this symptom is far less likely to return.

When it is a job for a pro#

Call a technician if the symptom persists after the checks above, if the repair means reaching power, gas, or sealed components, or if your Amana refrigerator is still under warranty — DIY work can void it. What you pay comes down to the failed component and the labor for your unit — a diagnostic visit confirms the number up front.

If the fix is beyond a quick DIY, request a technician who works on Amana refrigerators and can diagnose it in one visit.